DCP02161.JPG Tractor - 6/5/03 first attempt at OOPic 
DCP02162.JPG Tractor - modified servos, hot glue and tounge depressors
DCP02163.JPG Tractor - seperat batteries for OOPic and servos
DCP02164.JPG Tractor - a view of the bottom - servos strenghtened with one more tounge depressor
DCP02165.JPG Tractor - From overhead
DCP02166.JPG Tractor -
DCP02167.JPG Beverly the talking head - a wire sculpture first day with OOPic 6/5/03
DCP02168.JPG Beverly - two small unmodified servos - lower jaw and neck
DCP02169.JPG Beverly
DCP02170.JPG Beverly
DCP02171.JPG Tractor - inside shot of wheel and tounge depressor hub and servo horn
DCP02172.JPG Tractor
DCP02217.JPG Standup - 3rd attempt at a stand up balancing bot (no pictures of first two)
DCP02218.JPG Standup - started 6/10/03 same OOPic II - the photos are sideways... 
DCP02219.JPG Standup - July 1,03 but it is leaning on the wall doesn't balance much yet
DCP02220.JPG Standup - tounge depressor and pot from modified servo
DCP02221.JPG Standup - Dual motor driver board - 18200s 
DCP02222.JPG Standup - tounge depressor and pot from modified servo and encoder wheel
DCP02223.JPG Standup - servos modifiedi (gutted) to be DC motors
DCP02225.JPG Standup - OOPic and disk drive cable to prototype board